Environment Concerns - Zanussi zcg55dg Benutzerinformation

1. Remove the bottom plate of the oven cavity (A) to get
access to the oven burner (B).
2. Release the screw (C) which keeps the burner in po-
sition.
3. Carefully move the burner off the injector support
(D).
Slowly move it to the left side. Make sure that the
burner bush stays on the burner mouthpiece. Do not
apply force to the wire of the thermocouple conduc-
tor (F).
4. Release the injector (D) with a 7 mm socket spanner
and remove it. Replace it with the necessary one.
5. Assemble the burner in opposite sequence.
6. Replace the gas type sticker near the gas supply
ramp with the one related to the new gas type.
Minimum level adjustment of the gas oven burner:
1. Remove the oven control knob.
2. Adjust the adjustment screw (A) with a thin-bladed
screwdriver.
A

Environment concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
Change of the type of
gas
From natural gas to liq-
uid gas
From liquid gas to nat-
ural gas
3. Attach the oven control knob.
4. Light the oven burner. Refer to "Gas oven cooking:
Ignition of the gas oven burner".
5. Set the oven control knob to maximum and let the
oven heat for a minimum of 10 minutes.
6. Turn the oven control knob from maximum to mini-
mum.
Control the flame. If the flame goes out, do the procedure
from point 1 to point 6 again. There must be a small regu-
lar flame on the oven burner crown.
The manufacturer declines liability if you do not obey
these safety measures.
waste handling of this product. For more detailed
information about recycling of this product, please contact
your local council, your household waste disposal service
or the shop where you purchased the product.
Adjustment of the ad-
justment screw
Fully tighten the adjust-
ment screw in.
Release the adjustment
screw approximately
3/4 of a turn.
33