What To Do If; Installation - Zanussi ZOU233 Benutzerinformation

Oven lamp
Warning! There is a danger of electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or switch off the cir-
cuit breaker.
Put a cloth on the bottom of the oven for protection
of the oven light and glass cover.

What to do if...

Problem
The cooking zones do not operate
The oven does not heat up
The oven does not heat up
The oven lamp does not operate
Steam and condensation settle on the
food and in the oven cavity
If you can not find a solution to the problem, speak to your
dealer or the Service Force Centre.
These data are necessary to help you quickly and
correctly. These data are available on the rating plate (refer
to "Product description")
• Model description ............
• Product number (PNC) ............
• Serial number (S.N.) ............
Warning! Let a qualified electrician or competent
person do repairs to the appliance.

Installation

Building Under
Warning! Only a qualified and competent person
must do the installation of the appliance. If you do
not contact qualified or competent person, the guarantee
becomes invalid if there is damage.
• Before you built-under the appliance, install it with
applicable hob from the table.
Replacing the oven light bulb/cleaning the glass
cover
1. Turn the glass cover anti-clockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with applicable 300°C
4. Install the glass cover.
Possible cause
Consult the operating instructions for the built-in cooking surface
The oven is not switched on
The fuse in the fuse box is released
The oven lamp is defective
You left the dish in the oven for too
long
Important! If you do not operate the appliance correctly,
the visit from the Service Force Centre or dealer will not
be free of charge, even during the warranty period.
baking or roasting procedure, steam can show on the
glass.
• Make sure that the recess dimensions are applicable.
• Make sure that there is anti-shock protection for the
heat-resistant oven light bulb.
Switch on the oven (refer to chapter
"Daily use")
Control the fuse. If the fuse is re-
leased more than one time, refer to a
qualified electrician.
Replace the oven lamp
Do not leave the dishes in the oven
for longer than 15-20 minutes after
the cooking process ends
Hints for appliances with metal fronts:
If you open the door during or immediately after the
Type
ZME 2002
ZK 64
installation.
Remedy
Maximum power
6000 W
5800 W
17