Improper Use; Responsibility Of The Operator - WIKA TC46-Serie Betriebsanleitung

3. Safety
Neither repairs nor structural modifications are permitted, and any would void the
guarantee and the respective certification. The manufacturer shall not be responsible for
constructional modifications after delivery of the instruments.
EN
The instrument has been designed and built solely for the intended use described here,
and may only be used accordingly.
The technical specifications contained in these operating instructions and the related
data sheets must be observed. Improper handling or operation of the instrument
outside of its technical specifications requires the instrument to be taken out of service
immediately and inspected by an authorised WIKA service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary
to the intended use.

3.3 Improper use

Any use beyond or different to the intended use is considered as improper use.
Do not use this instrument in safety or emergency stop devices.
Electrical wires and transition are not to be in contact with hot surfaces (i. e. hot
manifolds). Where this cannot be achieved, a proper selection of electrical wire,
transition or high-temperature sleeve shall be used.

3.4 Responsibility of the operator

The instrument is used in the industrial sector. The operator is therefore responsible for
legal obligations regarding safety at work.
The safety instructions within these operating instructions, as well as the safety,
accident prevention and environmental protection regulations for the application area
must be maintained.
The operator is obliged to maintain the product label in a legible condition.
6
WARNING!
Injuries through improper use
Improper use of the instrument can lead to hazardous situations and
injuries.
▶
Refrain from unauthorised modifications to the instrument.
▶
Do not use the instrument within hazardous areas.
▶
Do not use the instrument with abrasive or viscous media.
WIKA operating instructions model TC46