Type Designation; Design Features - Johnson Pump L1600 12 V Handbuch

ENGLISH
Submersible bilge pump L1600, L2200 and L4000, 12/24 V
Submersible bilge pump for pumping bilge water in marine environment. To be installed in the
keelson.
Security
• The pump may not be used for other
liquids than water/bilge water.
• Always install the pump according to the
wiring diagram, see page 16-18.
• Always use the fuse required, see
"Design features" below.
• The wire connections must be sealed with
a marine sealant.
• Insulation or cable sheathings must be
placed above the highest bilge water level.
• Do not run dry.

Design features

Hose size:
Capacity, straight
(13,6V/27V):
(12V/24V):
Capacity, 1m head
(13,6V/27V):
(12V/24V):
Voltage:
Amperage:
Fuse size:
Body:
Shaft:
Shaft seal:
Wire size:
Max height:
Max dia:
Weight:
Installation
Please follow the installation instructions carefully to assure maximum efficiency in your
bilge pump operation.
1. Remove the strainer from the bottom of the pump by depressing the lock tabs on both
sides of the pump.
. Determine the desired location for the pump. Usually it is placed in the lowest point of
the bilge.
6
L1600
1¹⁄ "
8
100 l/min/(1 600 GPH)
9 l/min/(1 50 GPH)
98 l/min/(1 550 GPH)
88 l/min/(1 00 GPH)
1/ V DC
1 V – 7A
V – ,5A
1V – 10A
V – 6A
Thermoplastic
SS
Lip seal
1,5mm

19mm
108mm
1, kg

Type designation

Pumptype
L1600 1 V
L1600  V
L00 1 V
L00  V
L000 1 V
L000  V
L2200
1¹⁄ " or 1½"
8
10 l/min/( 060 GPH)
10 l/min/(1 900 GPH)
10 l/min/(1 900 GPH)
110 l/min/(1 750 GPH)
1/ V DC
1V – 7.5A
V – ,5A
1V – 1A
V – 6A
Thermoplastic
SS
Mechanical seal,
carbon/ceramic
1,5mm

177mm
108mm
,5 kg
Part nr
-1600-01
-1600-0
-00-01
-00-0
-000-01
-000-0
L4000
1½"or "
58 l/min/( 100 GPH)
5 l/min/( 000 GPH)
196 l/min/( 100 GPH)
16 l/min/( 600 GPH
1/ V DC
1V – 19,5A
V – 10A
1V – 5A
V – 15A
Thermoplastic
SS
Mechanical seal,
carbon/ceramic
1 Gage
16mm
11mm
,5kg