Battery Charger; Language Selection - Motorola PMMN4096 Bedienungsanleitung

To avoid a possible explosion:
! !
•
DO NOT replace the battery in any area labeled
"hazardous atmosphere".
W A R N I N G
•
DO NOT discard batteries in a fire.
The Motorola Solutions-approved battery shipped with your WRSM is
uncharged. Prior to using a new battery, fully charge the new battery to
ensure optimum capacity and performance.
NOTE:
When charging a battery attached to a WRSM, turn the
WRSM OFF to ensure a full charge.

Battery Charger

To charge the battery, place the battery, with or without the WRSM, in a
Motorola Solutions-approved charger. When initially inserting the
battery into the charger, the charger's LED will turn red. DO NOT use
WRSM until the charger's LED turn Green,
The charger's LED indicates the charging progress; see 3 and 4 or the
label printed on the charger.
Align the slot of the battery with the charger's rail and slot in. Refer to
Figure 2.4.
10
English

Language Selection

Follow the procedure below if you want to reset to your desired
language. Ensure that the WRSM is powered OFF before starting this
procedure.
Procedure:
1
Press and hold the PTT button before powering ON the WRSM.
DO NOT release the PTT button.
2
Continue holding the PTT Button until the prompt to select
language.
3
Select your desired language by pressing the PTT button. Refer to
Table 2.1 below for the Language Selection Indicators.
Table 2.1: Language Selection Indicators
State Power Indication LED
Language Selection LED illuminated
Voice Prompt
"For English press PTT
now" (Menu selection
prompts)