Operating Instructions - Motorola PMMN4096 Bedienungsanleitung

Operating Instructions

Dual-Unit Chargers are intended for use only with the authorized
Motorola Solutions battery and power supplies listed in Table 3.1
and Table 3.2; usage with unauthorized products may prevent
proper operation and may damage the device.
The battery charger will accommodate a WRSM with an attached
battery or battery alone in either pocket. To charge a battery, use the
following procedure:
1
Plug the power supply cord into the barrel connector on the back of
the charger.
2
Plug the power supply into the appropriate AC outlet. The charger
LED will flash single green once to indicate a successful power-up.
3
Insert a WRSM with battery into the charger's pocket by:
a
Aligning the groove on each side of the battery with the
corresponding raised rail on each side of the charger pocket.
b
Sliding the WRSM with battery into the charger pocket,
ensuring complete contact between the charger and battery
contacts.
4
When the WRSM with battery is properly seated in the pocket, the
charger LED will light in accordance with Table 3.3.
5
Insert a battery into the charger's pocket by:
a
Aligning the slot on each side of the battery with the
corresponding raised rail on each side of the charger pocket.
24
English
b
Sliding the battery into the charger pocket, ensuring complete
contact between the charger and battery contacts.
6
When the battery is properly seated in the pocket, the charger LED
will light in accordance with Table 3.3.
NOTE:
Charge new batteries overnight to ensure full charge. To
minimize charge time, it is recommended to turn the WRSM
OFF.
The Dual-Unit Charger is not designed to accommodate the
alkaline battery tray.
Figure 3.3: Charging position of the WRSM on a Dual-Unit Charger