Programming Inputs; Calibration Procedure Notes - Balluff BTL7-A510-M Serie Betriebsanleitung

BTL7-A/G510-M _ _ _ _ -H/W(8)-SA378-S32/S115/_ _ _
Micropulse Transducer - Rod Style
6
Calibration procedure
Output Linear
gradient transducer
Rising BTL7-A...
(output 1)
BTL7-G...
Rising BTL7-A...
(output 2)
BTL7-G...
Tab. 6-1: Value table for adjustment
6.1

Programming inputs

Programming inputs La and Lb must be used in order to
make settings. A programming input at 10 to 30 V
corresponds to activation (high active).
The Balluff BTL7-A-CB02-... calibration box can be used
for this (see Accessories on page 24).
Automatic deactivation!
If no signals are transmitted via the
programming inputs for approx. 10 min,
programming mode is automatically ended.
6.2

Calibration procedure notes

Prerequisites
– Programming inputs are connected.
– The transducer is connected to the system controller.
– Voltage values from the transducer can be read (using
a multimeter, the system control or the calibration box).
Fig. 6-1: Connecting the BTL7-A-CB02-S... calibration box
www.balluff.com
Unit Min. Null value
value
V -0.5 0
V -10.5 -10.0
V -0.5 0
V -10.5 -10.0
BTL
Adapter cable with
connector (socket)
Indication for End value
adjustment
4.0 +10.0
4.0 +10.0
2.0 +10.0
2.0 +10.0
Values for null and end point
– Any desired position of the magnet can be used as the
null or end point. However, the null and end points may
not be reversed.
– The absolute null and end points must lie within the
minimum or maximum range of what can be output
(see value table).
The last set values are always saved, regardless
of whether the setting was ended using the
programming inputs or automatically after
10 min have expired.
Value table for adjustment
The following examples refer to transducers
with 0 to 10 V output.
Calibration box
8-pin 6-pin
Adapter cable with
connector (luster terminal)
Max. Error
value value
+10.5 +10.5
+10.5 +10.5
+10.5 +10.5
+10.5 +10.5
Supply
english 13