Procedure To Release The Immobilizer Using The Throttle Twistgrip - Ducati SUPERBIKE 749R 2006 Anleitung- Und Instandhaltungsheft

Procedure to release the immobilizer using the
throttle twistgrip
1) Turn the ignition key to ON and fully open the throttle.
Keep it open.
The EOBD warning light (8, fig. 4) goes off after the
pre-set time of 8 seconds.
2) Release the throttle as soon as the EOBD warning
light turns off.
3) The EOBD warning light will light up again and flash.
Now enter the electronic release code shown on the
CODE CARD given to the customer when the
motorcycle was delivered by the dealer.
4) Count a number of flashes of the EOBD (8, fig. 4) light
equal to the first number of the secret code.
Open the throttle twistgrip, keep fully open for
2 seconds, then release. The digit entered is
acknowledged, and the EOBD warning light comes
on and stays on for the pre-set time of 4 seconds.
Repeat the operation until you have entered the final
digit.
If no operation is performed with the throttle, the EOBD
light will flash 20 times and then come on steadily.
In this case, repeat the procedure from step (1).
5) When you release the throttle, if the code was
entered correctly, there are two cases, A or B:
A) the EOBD light flashes to indicate that the engine
is enabled. The light switches off after 4 seconds,
or if engine speed exceeds the threshold value of
1000 rpm.
B) the CODE (12, fig. 4) light flashes until engine rpm
exceeds 1000 rpm or until the vehicle is restarted.
6) Should the code NOT be entered correctly the EOBD
light and CODE symbol stay on and the procedure can
be repeated starting from step 2 for as many times as
necessary.
Notes
If the throttle twistgrip is released before the pre-set
time, the warning light comes on again, and it is necessary
to turn the key to OFF and repeat the procedure from
step (1).
E
23