Honda F560 Bedienungsanleitung Seite 45

3. Clean both filter elements if they are to be reused.
Foam element:
Clean in warm soapy water, rinse and allow to dry thoroughly. Or clean in high
flash-point solvent and allow to dry. Dip the element in clean engine oil and
squeeze out all the excess. The engine will smoke during initial start-up if too
much oil is left in the foam.
Clean
Paper element:
Tap the element lightly several times on a hard surface to remove excess dirt, or
blow compressed air through the filter from the inside out. Never try to brush
the dirt off; brushing will force dirt into the fibers. Replace the paper element if
it is excessively dirty.
4. Securely install the elements and the air cleaner cover.
5. Close the engine upper cover and turn the cover lock to the LOCK position
(see page 41).
42
Squeeze and dry
Do not twist.
Dip in oil Squeeze
Do not twist.