What To Do If - AEG 96931K-MN Benutzerinformation

14

What to do if...

Cleaning the appliance after each use
1. Food containing sugar, plastics, tin foil residues should be removed at once using a
scraper. Place a scraper on the glass ceramic surface at an angle and remove residues
by sliding the blade over the surface. Wipe the appliance with a damp cloth and a little
washing up liquid. Finally, rub the appliance dry using a clean cloth .
2. Limescale rings, water rings, fat splashes, shiny metallic discolorations should be re-
moved after the appliance has cooled down using cleaner for glass ceramic or stainless
steel.
What to do if...
Problem
The cooking zones will not
switch on or are not function-
ing
Acoustic signal sounds when
appliance is switched off
The residual heat indicator is
not displaying anything
The automatic warm up func-
tion is not switching itself on
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
Possible cause
More than 10 seconds have
passed since the appliance was
switched on
The child safety device is
switched on
Several sensor fields were
touched at the same time
Automatic switch off has been
triggered
There is water on the control
panel, or the control panel is
covered with splashes
is active -
The control panel is wholly or
partly covered by objects.
The cooking zone was only on
for a short time and is therefore
not hot
There is still residual heat on
the cooking zone
The highest heat setting is set
The On/Off sensor field has
been covered up, e.g. by a cloth
Remedy
Switch the appliance on again.
Deactivate child safety device
(See the section "Child safety
device")
Only touch one sensor field
Remove any objects (pan,
cloths, etc.) that are lying on
the control panel. Switch the
appliance on again
Wipe the control panel
Switch off
Remove objects.
If the cooking zone is supposed
to be hot, call the Customer
Service Department.
Let the cooking zone cool down
The highest heat setting has
the same power as the auto-
matic warm up function
Do not place any objects on the
control panel