E N G L I S H
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor size
2
is 1.5 mm
. When using a cable reel, always unwind
the cable completely. Also refer to the table below.
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
17
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
Assembly and adjustment
Replacing the saw blade (fig. B)
• Move the blade clamp slider (6) up to release
the blade clamping mechanism.
• Insert the saw blade into the holder (5) until it
engages. The blade can be installed with the
teeth pointing down or up.
• Move the blade clamp slider (6) down to lock the
blade clamping mechanism.
• To remove the saw blade, proceed in reverse order.
.
Saw blades
material
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available
as an option.
Setting the adjustable saw shoe (fig. C)
The saw shoe can be adjusted to limit the depth of
cut and prolong the life of your saw blade.
• Push and hold the release button (3).
• Slide the saw shoe (2) into the desired position.
• Release the button.
60
Instructions for use
6
10
15
• Always observe the safety instructions
20
25
• Ensure the material to be sawn is
-
-
-
• Apply only a gentle pressure to the tool
6
6
6
6
15
15
20
-
Prior to assembly and adjustment always
unplug the tool.
recommended saw blade
fine-toothed
coarse-toothed
TCT saw blade
fine-toothed
carbide-tipped
Always select your saw blade with great
care.
and applicable regulations.
secured in place.
and do not exert side pressure on the
saw blade. If possible, work with the saw
shoe pressed against the workpiece.
This prevents damage to the blade and
stops the tool from jerking and vibrating.
en - 4