Commissioning; Hazard - JAC DIV Bedienungsanleitung

This machine complies with Machinery Directives 2006/42, 2014/35, 2014/30 and is CE-marked as
proof of this compliance.
Please familiarise yourself with the safety pictograms displayed on the machine:
This pictogram indicates an electrocution hazard. Please isolate the machine
before carrying out any work on it. You will find this pictogram inside the machine
on the electrical enclosure (fig.13, n°21).
You will find the circuit diagram for the machine inside the left-hand door of the
divider (fig.13, n°22).
This pictogram indicates a crushing hazard. Please isolate the machine before
carrying out any work on it. You will find this pictogram on the side doors (fig.13,
n°23).
5.4

Commissioning

Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
Ensure first of all (after verifying electrical compatibility) that the motor is rotating in the right direction;
if so, the heads will rise when you pull the control lever towards you. If this is not the case, disconnect
the plug and switch 2 phases in it.
For machine operation, refer to the "Operation" chapter.
5.5

Hazard

If the user or the machine is in danger, use the emergency stop to stop the machine.
Remove the plug from the mains socket before any maintenance and/or servicing work.
Any maintenance work or replacement of parts must be carried out by an approved agent.
English
10