Connecting The Cooling Device - Waeco COOLMATIC MDC-50 Bedienungsanleitung

Setting up and connecting the cooling device
6.4 Changing the decorative plate
You can change the decorative plate on your cooling device to improve
the appearance.
This is how to change the decorative plate:
➤ Remove the screws 1 and 3 (fig. 5 1 and 3, page 5).
➤ Remove components 2 and 4 (fig. 5 2 and 4, page 5).
➤ Pull down the old decorative plate out of the door frame.
Caution: there is a risk of injury!
➤ Put the new decorative plate in the door frame.
➤ Fit the components 2 and 4 (fig. 5 2 and 4, page 5) back on the device.
➤ Fasten the screws 1 and 3 (fig. 5 1 and 3, page 5).
6.5

Connecting the cooling device

For the electrical connection you also need the wiring diagram (fig. 6,
page 5).
No. in
fig. 6, Meaning
page 5
1 Electronic terminal rail
2 Compressor
3 Temperature controller
Cable colours:
No. in
fig. 6, Meaning
page 5
bl Blue
br Brown
28
COOLMATIC MDC Series