Remote Control Via A Terminal Program - Wenglor Y1TA-Serie Bedienungsanleitung

EN
Connect the sensor to the PC, the controller etc. via the wenglor S232W3 plug adapter. Install the plug adapter
as follows:
• Disconnect the 8-conductor connector cable (S80-xx) from the sensor.
• Connect the S232W3 plug adapter directly to the sensor.
• Connect the 8-conductor connector cable (S80-xx) to the plug adapter.
• Connect the 9-pin subminiature socket connector at the PC to the serial interface.
• Switch the power supply on.
Sensor

8.1 Remote Control via a Terminal Program

1. Connect the sensor as described in chapter 7 above.
2. Set the sensor to the Interface menu mode.
à Select the "Interface" menu item.
à Select "Mode".
à Select "Menu".
Alternatively: Select <Comm> and with F1, select remote control via Terminal-Program.
The remote control via Terminal-Program can be ended with F4.
3. Start the terminal program at the PC,
for example start the Windows
à Start à Programs à Accessories à Communication à HyperTerminal.
– Settings: 38,400 baud, 8, N, 1
– Select the utilized port (e.g. COM 1).
– Establish a connection.
The menu appears in the terminal program.
Sensors for your success
59
S232W3
PC or Controller
® HyperTerminal
www.wenglor.com Sensors for your success
® by clicking
Power Supply
Outputs
www.wenglor.com