Safety Precautions - Eufab 11511 JAKE Bedienungsanleitung

4. SAFETY PRECAUTIONS

• The warning triangle labels all instructions important to
safety. Always follow these otherwise you could injure yourself or
damage the device.
• Children may not play with the device.
• Cleaning and user maintenance may not be carried out by
children without supervision.
• Do not treat packaging material carelessly. This may become a
dangerous plaything for a child!
• Only use this product for its designated purpose!
• Do not manipulate or disassemble the device!
• For your own safety, only use accessories and spare parts that
are stated in these instructions or that are recommended by the
manufacturer!
• Continue to observe the safety precautions in the instructions for
your bicycle rack.
5.OPERATING INSTRUCTIONS
5.1 PREPARATION
If you have already used your JAKE bicycle rack, you will rst need to remove the
cable set from the bicycle rack. To do this, cut through the cable ties. You will need
8 new cable ties (not included in the scope of delivery of the expansion) to reattach
the cable set after installation. If you are tting the expansion to a JAKE bicycle
rack that is straight from the factory, you can use the cable ties from the scope of
delivery of the bicycle rack instead.
5.2 INSTALLING THE EXPANSION TO THE EXISTING BICYCLE RACK
Undo the two hexagonal screws (Figure 1) on the underside of the rear end of the
rack table and remove fully. Put the screws to one side so that they will not be lost.
Pull the lamp mount fully out of the rack table.
Undo the nut and pull the carriage bolt from the attachment base of the expansion
rail (Figure 3 and 3 a).
Remove the ller element and sleeve from the attachment base (Figure 4).
Figure 4: Removing the ller element and sleeve
Figure 1: Screws of rack table
Figure 2: Remove the lamp mount
Figure 3: Attachment base
Figure 3a: Remove the carriage bolt
Fit the sleeve to the pipe of the lamp mount (Figure 5).
Place the expansion rail on the sleeve (Figures 6 and 7). To do this, the closures
must face forwards in the direction of travel (Figure 8).
Figures 6 and 7: Figures 6 and 7: Figures 6 and 7:
Position the expansion rail Position the expansion rail Position the expansion rail
Replace the ller elements back in the attachment base. Fit the carriage bolt from
the outside, on the side with the square socket, into the attachment base, and t
the washers and nuts. Do not tighten the nuts yet.
Now insert the pipes of the lamp mount back into the rack table. Slide the pipes in
far enough that the marks (Figure 9) on the pipes are just hidden.
Screw the hexagonal screw back into the bottom of the rack table. Pay attention to
ensure that the screws go through the drilled holes in the pipes of the lamp mount.
Tighten the screws.
Now align the expansion rail, as far as possible to the back and parallel to the rear
lights. Tighten the nuts in the attachment base. Fit the protective caps (Figure 10)
onto the nuts.
Close the rear drilled holes in the pipes of the lamp mount using the end caps
(Figure 11).
Figure 5: Fitting sleeves
Figure 8:
Installation position of closures
Figure 9: Marks on the lamp mount
Figure 10: Protective cover
Figure 11: End caps
5