Glossary; Introduction - OJ Electronics ETO2 Anleitung

COnTEnTs
Glossary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Startup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Main menu . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Display texts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Application info . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Restart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Offset calibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Factory settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

GlOssary

Zone 1, 2: Independent heating zones in which ice and snow can be melted.
Encoder button: Button which can be turned or pressed to easily configure the settings.
ETOG-55: Ground sensor for detecting moisture and temperature.
ETOR-55: Gutter sensor for detecting moisture.
ETOG-56/ETOK-1: Embedded ground sensor for detecting moister and temperature.
ETF-744/99: Outdoor sensor for detecting temperature.
Y/Δ: Advanced 2-stage control of electric heating systems.
Afterrun: The heat provided by the system, for a specified length of time, after the moisture/
temperature signal has been eliminated by a heating cycle.

InTrOduCTIOn

Type ETO2 is an electronic controller for fully automatic, economical ice and snow melting on outdoor
surfaces and in gutters. Ice forms due to a combination of low temperature and moisture. ETO2 detects
both temperature and moisture and the heating system will only be activated if a possibility of ice or
snow is indicated by both parameters.
An easily operated encoder button and backlit graphic display ensure quick and easy configuration and
simple indication of temperature, status, etc.
ETO2 is suitable for controlling electric heating cables in 1 or 2 zones. It also features advanced two-
stage output control for economic operation.
© 2014 OJ Electronics A/S - ® The OJ trademark is a registered trademark belonging to OJ Electronics A/S
English
User Manual
Page 43
Page 43
Page 44
Page 45
Page 45
Page 45
Page 46
Page 46
Page 48
Page 49
Page 49
Page 49
43