Information Codes - Samsung DW60M5070-Serie Benutzerhandbuch

Troubleshooting
PROBLEM
Dishwasher leaks
Buttons are not
working on power on
state
The result of washing performance may be caused by a power supply issue. Try another program
before contacting for service.

INFORMATION CODES

When a fault occurs, the appliance will display information codes to warn you.
Codes
4C Water supply check
LC Leakage
HC Not reaching required temperature
PC Divider valve failed
Failure of communication between main
AC
PCB with sub PCB
bC2 Button pressed long time
WARNING: If overflow occurs, turn off the main water supply before calling a service. If there is water
in the base pan because of an over fill or small leak, the water should be removed before restarting the
dishwasher.
46_ Troubleshooting
DW5500MM_DW6KM5031BB_EG_DD81-02615L-00_EN.indd 46 DW5500MM_DW6KM5031BB_EG_DD81-02615L-00_EN.indd 46
POSSIBLE CAUSE
• Overfill dispenser or rinse
aid spills.
• Dishwasher isn't level.
• Door is open.
• Control lock function is
selected.
Meanings
WHAT TO DO
• Be careful not to overfill the rinse aid
dispenser.
Spilled rinse aid could cause overusing
and lead to overflowing.
Wipe away any spills with a damp cloth.
• Make sure the dishwasher is level.
• When door is opened, buttons are not
working except POWER button. Close
the door and press the button.
• When selected Control lock function,
buttons are not responded. To
unlock this function, hold down the
Control lock button for three (3)
seconds.
Also, Control lock function is released
when power cord is reconnected.
Possible Causes
Faucets is not opened, or water intake is
restricted,or water pressure is too low
Some element of dishwasher leaks.
Malfunction of heating element
Divider valve failed
Open circuit or break wiring for the
communication
Button pressed 30 seconds
2019-11-08 2019-11-08 5:29:57 5:29:57