Herunterladen Inhalt Inhalt Diese Seite drucken

Bedienung; Operation - Endress+Hauser iTEMP TMT80 Montage

Temperaturkopftransmitter
Inhaltsverzeichnis

Werbung

TMT80
de

Bedienung

Die Konfiguration des Kopftransmitters erfolgt mit der PC-Software
®
ReadWin
2000, die als Zubehör (s. Seite 7) erhältlich ist.
!
Hinweis!
Bei angeschlossenem Schnittstellenkabel (siehe 'Zubehör' auf Seite 7)
werden die technischen Spezifikationen (z. B. Messabweichung)
nicht eingehalten. Trennen Sie daher während des Messbetriebs die
Verbindung über das Schnittstellenkabel zwischen Kopftransmitter
und PC.
Folgende Tabelle zeigt die Struktur der menügeführten Bedienung
der PC-Konfigurationssoftware ReadWin
Einstellbare Parameter
Standardeinstellu
• Sensortyp
• Anschlussart (2-, 3- oder 4-Leiterschaltung)
ngen
• Messeinheit (°C/°F)
• Messbereichsgrenzen (abhängig vom Sensor)
• Kompensation Leitungswiderstand
(0 bis 20
• Fehlerverhalten ( 3,6 mA oder
bei Einstellung
Ausgangsstrom
• Offset (-9,9 bis +9,9 K)
Ausführliche Informationen zur Konfiguration über ReadWin
finden Sie in der Online-Dokumentation der PC-Software.
6
®
2000:
Ω)
bei RTD 2-Leiterschaltung
21,0 mA;
21,0 mA ist ein
21,5 mA garantiert)
®
en

Operation

Head transmitter set-up is done using the ReadWin
ware. This is available as an accessory (see page 7).
!
Note!
When the interface cable is connected (see 'Accessories' on page 7),
the technical specifications (e.g. measured error) are not observed.
For this reason, during operation disconnect the connection via the
interface cable between the head transmitter and PC.
The following table shows the structure of the PC-Configuration
®
software ReadWin
Presettable parameters
Standard settings • Sensor type
2000
For detailed ReadWin
on-line documentation contained in the ReadWin
2000 interactive menu operation:
• Connection mode
(2-, 3- or 4-wire connection)
• Units (°C/°F)
• Measurement range limits
(depends on sensor)
• Compensation resistance (0 to 20
on RTD 2-wire connection
• Fault condition reaction (
21.0 mA; if setting is
signal
21.5 mA is guaranteed)
• Offset (-9.9 to +9.9 K)
®
2000 operating instructions please read the
®
2000 PC soft-
Ω)
3.6 mA or
21.0 mA, a output
®
2000 software.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis