Data Storage in the internal memory
1.
Press MODE.
2.
Select [DATA] and press OK.
Start the data-logging
1.
Select [ACTIVATE] and press OK.
2.
Decide whether data-logging should be carried out or not and press OK.
3.
Select [CONTINUOUS] and press OK.
4.
Decide whether the oldest data should be overwritten when the memory limit is reached or not and press
OK.
5.
Select [INTERVAL] and press OK.
6.
Select the desired time interval between the data-logging and press OK.
7.
Return to the measurements by pressing MODE.
8.
The data-logging starts according to the previous settings while the display shows the logging-number
e.g. [LOG.00027].
Process the stored values
1.
Select [PROCESS] and press OK.
2.
Select [TABLE] or [SEND] to display or send the stored data and press OK to continue. Follow the
instructions on the screen.
Erase the stored values
1.
Select [PROCESS] and press OK.
2.
Select [ERASE] and press OK. Follow the instructions on the screen.
External storage in a computer using USB or RS232
1.
Press MODE.
2.
Select [SERIAL PORT] (only on Ethernet versions) and press OK.
3.
Select [INTERVAL] and press OK.
4.
Select the desired interval between the transmitted data and press OK. Pre-set to zero if no automatic
transmitting is required.
5.
Select [BAUD] and press OK.
6.
Select the desired transmission rate and press OK.
•
You can download free software and a suitable USB driver or an Ethernet configuration document from
www.consort.be.
7