Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation of the instrument
Inputs
The measuring electrodes should be connected to the coaxial connectors CH1 or CH2. Automatic temperature
compen- sation and measurement are possible by connecting a Pt1000 temperature compensator to the banana
connectors °C1 or °C2. Without compensator, the manual temperature compensation is automatically switched
on.
Outputs
A standard USB port is provided for interfacing the instrument with a computer or network. A standard RS232 port
is provided for interfacing the instrument with a printer. Data is sent in the ASCII code at a BAUD rate of
1200...115200 bps (8 bit, no parity, 1 stopbit).
Language
1.
Press MODE.
2.
Select [SYSTEM] and press OK.
3.
Select [LANGUAGE] and press OK.
4.
Select the desired language and press OK
Contrast
1.
Press MODE.
2.
Select [SYSTEM] and press OK.
3.
Select [CONTRAST] and press OK.
4.
Adjust the contrast and press OK.
Date and time
1.
Press MODE.
2.
Select [SYSTEM] and press OK.
3.
Select [DATE/TIME] and press OK.
4.
Select [MODIFY] and press OK.
5.
Adjust date and time and press OK.
Password
1.
Press MODE.
2.
Select [SYSTEM] and press OK.
3.
Select [PASSWORD] and press OK.
4.
A private code can be programmed to avoid undesired access to the instrument. Select [YES] and press
OK to enter your secret sequence of 5 keys.
Stand by
1.
Press MODE.
2.
Select [STAND BY] and press OK.
3.
Select [YES] (= continue automatically after a power failure) or [NO] (= instrument can be switched off).
Channels
1.
Press MODE.
2.
Select [CHANNELS] and press OK.
3.
Select the desired channel and press OK.
4.
Select the desired range and press OK.
5.
Select the desired input for temperature compensation and press OK.
User standard tables
•
Press MODE.
•
Select [USER TABLES] and press OK.
•
Select [pH buffers] or [S/cm standards] and press OK.
•
Follow the instructions on the screen to enter the different values. The value for 25°C is obligatory!
2
Werbung
Inhaltsverzeichnis
