General Informations - Consort C32 Serie Anleitung

General Information
Introduction
This instrument is manufactured with the latest technology and needs no particular maintenance. Consort
certifies that this instrument was thoroughly inspected and tested at the factory prior to shipment and found to
meet all requirements defined by contract under which it is furnished. However, dimensions and other physical
characteristics may differ.
The normal operating temperature should be between 0° and 40°C. Never use the instrument in a room with
high humidity (>95 %) or at very low temperatures (condensation water!).
Manufacturer
Consort BV
Hertenstraat 56/9 Tel (+32)(14)41 12 79
B2300 Turnhout Fax (+32)(14)42 91 79
Belgium E-mail: info@consort.be
Warranty
This instrument (excluding all accessories) is warranted against defective material and workmanship for period
of thirty-six (36) months from the date of shipment ex factory. Consort will repair all defective equipment
returned to it during the warranty period without charge, provided the equipment has been used under normal
laboratory conditions and in accordance with the operating limitations and maintenance procedures in this
instruction manual and when not having been subject to accident, alteration, misuse or abuse. A return
authorisation must be obtained from Consort before returning any product for warranty repair on a freight
prepaid basis!
Consort is not liable for consequential damages arising out of the use or handling of its products.
Servicing
In the event of this instrument being returned for servicing, the owner is requested NOT to send the following
items unless they are suspect:
Manual
Cables
Accessories
If serious malfunctioning occurs, stop using the unit immediately and consult your local Consort dealer.
AC adaptor
Connect the mains adapter to the DC socket. Do not hold the adapter by wet hand.
Keyboard
MODE = Selects the settings or escapes from error traps, calibration procedures, etc..by
returning to the original mode.

= Buttons for browsing between the selected modes, for entering a value or for value
selecting a function
OK = Proceeds a function.
CAL = Starts a calibration.
STORE = Stores the displayed value or send it to a computer or printer.
HOLD = Holds display when measuring.
1