Loop Recording - VANTRUE OnDash N2 Pro Bedienungsanleitung

!
OK
P
!
OK
P
Please go to System Setup to adjust this time to
1, 3, 5, or OFF to disable it so the LCD can
always stay on.

4.6 Loop Recording

After inserting a memory card, the camera will
(by default) immediately start loop recording
video when connected to a power source and
powered ON. If the device is not connected to
a power source, it will not immediately start
recording after you press the Power ON button
– press the OK button to start recording.
While recording, the LED indicator will blink and
a red dot will flash on the top left of the screen.
You can stop/start the recording at any time by
pressing the OK button.
1080P+1080P 0:23
3
0
03:07:29 01/01/2019
- 18 -