Blade Replacement - Cembre HT-TC026Y Bedienungsanleitung

ENGLISH
h – Remove all air from reservoir and fi t cap (01).
i – Assemble main handle (03) to tool body.
If the tool continues to malfunction return the tool for service/repair as detailed in § 6.
4.2) Oil top up
Every six months check the oil level in the reservoir. If necessary, top up the oil level to the top lip
of the reservoir and remove all air from reservoir, see § 4.1, points a, b, c, e, g, h and i.
Always use clean recommended oil, see § 1.
Do not use old or recycled oil.
Do not use hydraulic brake fl uid.
Ensure that disposal of used oil, is in accordance with current legislation.

4.3) Blade replacement

After extended use, the blades may loose their cutting edge. Replace the blades as follows:
4.3.1) Lower blade: (Ref. to Fig. 4)
– Release latch (25), and open the tool head completely.
– Operate the tool to advance the lower blade (24).
– Eject two split pins (26-67) from the ram (28) to release the blade (24).
– Remove the broken blade from the ram, insert the new blade and fi t with two split pins.
Warning: before closing the tool head release the oil pressure and retract the lower blade, otherwise
the head may hit and damage, the lower blade.
4.3.2) Upper blade: (Ref. to Fig. 5)
– Release latch (25) and open the tool head.
– Remove the circlip (59) and partially extract the head pin (15), enough to release the tool head
assembly.
– Remove circlip (29) and pin (23), to release the latch (25).
Remove latch spring (22) from the spacer (19).
– Using a 10 mm spanner, remove 8 nuts (16), 8 washers (18) and 4 studs (17), releasing the blade
(21).
– Position the new blade in the head assembly, insert 4 studs (17), fi t 8 washers (18) and 8 nuts (16).
Insert the latch spring (22) into the spacer.
Fit the latch using the pin (23) and circlip (29) and tighten the 8 nuts.
– Fit the head assembly to the head support using the pin (15) and circlip (59).
6