Toro Flex-Force Power System 60V MAX Bedienungsanleitung Seite 9

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Note:
The battery pack is not fully charged when you
purchase it. Before using the machine for the first
time, refer to Charging the Battery Pack (page
1
Mounting the Battery
Charger (Optional)
No Parts Required
Procedure
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry place),
near a power outlet, and out of the reach of children.
Refer to Figure 2 for assistance in mounting the
charger.
Slide the charger over the appropriately positioned
hardware to secure the charger in place (hardware
not included).
Description
No parts required
No parts required
Chute deflector
Chute-control rod
Qty.
–
–
1
1
13).
7
Use
Mount the battery charger (optional).
Unfold the handle.
Install the chute deflector.
Install the chute-control rod.
Figure 2
g247359