Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Fitting/Changing The Saw Blade; Adjusting The Footplate - Parkside PSSA 20-Li A1 Originalbetriebsanleitung

Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Allow the battery pack
in the appliance .
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
the status of the battery (see also main diagram) .
The status will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Fitting/changing the saw blade

WARNING!
► Remove the battery before carrying out
any work on the power tool (e.g. mainte-
nance, changing tools, etc.) as well as during
the transport and storage of the power tool.
Unintentional activation of the ON/OFF
switch can result in injury .
♦ Turn the quick-release chuck
stop and hold it in this position .
♦ Push the required saw blade
quick-release chuck
■ 8 │ GB │ IE │ NI
to click into place
and remove the
to check
as far as the
into the
as far as the stop .
CAUTION!
► The teeth of the saw blade
downwards!
♦ Let go of the quick-release chuck
returns to its initial position . The saw blade
is now locked .

Adjusting the footplate

RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance .
♦ Adjust the footplate
depth .
♦ To do so, undo the locking lever
the footplate to the corresponding position .
♦ Lock this position by closing the locking lever

Adjusting the pendulum stroke

♦ You can use the pendulum stroke switch
to adjust the pendular movement of the saw
blade . You can achieve fine, clean-cut edges
without pendulum movement (setting "0") .
Deactivate pendulum movement when working
on thin workpieces . You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (setting "I") .
must point
so that it
according to the cutting
and move
PSSA 20-Li A1
.