Screw (+Psw 4 × 10); Screw (+Psw 4 × 20) - Sony SU-WL450 Installationsinformationen

WARNING
 Be sure the TV or LCD Monitor is on the vertical
position before switching on. TV or LCD Monitor set
must not powered on with LCD panel face down to
avoid uneven picture uniformity.
 If pressure or shock is applied to the surface of the
TV or LCD Monitor, the TV or LCD Monitor may
break or become damaged.
 Lay the TV or LCD Monitor face down on a stable
and level surface with the Table-Top Stand hanging
over the edge of the surface. Having the TV or LCD
Monitor face and the base of the Table-Top Stand
on the same level surface will create an unstable
working condition and can damage the TV or LCD
Monitor.
 When detaching the Table-Top Stand from the TV
or LCD Monitor, hold the Table-Top Stand securely.
2
Remove the screws from the rear
of the TV or LCD Monitor.
3
Attach the Wall-Mount
Attachment
VS
the TV or LCD Monitor) to the
rear of the TV or LCD Monitor (to
make it parallel with the wall).
VS
(supplied with
1.5 N·m
{15 kgf·cm}
− 14 (GB) −
Note
 Be sure to fasten the Wall-Mount Attachment
VS
when attaching them to the TV or LCD
Monitor.
Use only a flat head screwdriver to install the
Wall-Mount Attachment
might result in over torqueing the Wall-Mount
VS
Attachment and damaging the TV or LCD
Monitor.
4
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring
to "Supplied with SU-WL450" in
"Checking the Parts" on page
7.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
If standard mounting (2-a) is selected:
 Spacer (60 mm)
 Screw
 Belt
If slim mounting (2-b) is selected:
 Spacer (20 mm)
 Screw
 Belt
VS
. Use of another tool
(+PSW 6 × 50)
 Screw
(+PSW 6 × 20)
 Pulley
(+PSW 6 × 20)
 Screw
(+PSW 6 × 20)
 Pulley