Other Information; Confirming The Completion Of The Installation - Sony SU-WL450 Installationsinformationen

3
Preventing the bottom of the TV
or LCD Monitor from shifting.
• Take up the slack of Belt  and attach it
to the wall tightly.
2-a
 Belt
• Use a 5 mm diameter screw or equivalent
(not supplied).
Note
 Try to pull the bottom of the TV or LCD Monitor
towards yourself slightly, to make sure that it does
not move forward. If there is any movement, it is
not fixed correctly, and the Belt  should be
secured firmly again.
Confirming the Completion of
the Installation
Check the following points.
 The Pulleys  are firmly hung onto the Base
(20)  or Base Adaptor .
 The cord and the cable are not twisted or
pinched.
 The Belt  is tight with no slack.
WARNING
 Improper placement of the AC power cord (mains lead),
etc. may cause fire or electric shock through a short
circuit. Be sure to confirm the completion of the
installation for safety.
2-b
 Belt
− 20 (GB) −

Other Information

When removing the TV or LCD Monitor, reverse
the previous installation procedure.
WARNING
 Be sure that two or more persons (three or more
persons for 189.3 cm (75 inches) and above TV or LCD
Monitor set) hold the TV or LCD Monitor when
removing it.
Specifications
f
g
d
c
b
a
Dimensions: (Approx.) [mm]
a : 400
b : 300
c : 200
d : 100
e : 80
f : 480
g : 100
h1 : 20 (for slim mounting, 2-b)
h2 : 60 (for standard mounting, 2-a)
Mass (base only): (Approx.) [kg]
0.8
Design and specifications are subject to change without
notice.
h1 h2
e