What To Do If - IKEA FWM6 Handbuch

ENGLISH
The dangers of freezing
If the appliance is installed in a place where
the temperature could drop below 0°C,
proceed as follows to remove any water re-
maining inside the appliance:
1. unplug the appliance;
2. turn off the water tap;
3. unscrew the water inlet hose from the
tap;
4. unfasten the drain hose from the rear
support and unhook it from sink or spi-
got;
1

What to do if...

The appliance does not start or stops during
operation. It is possible that the red indica-
tor light of button 4 blinks to indicate that
the appliance is not working.
Problem Possible cause
The door has not been closed (The
red indicator light of button 4
blinks).
The plug is not properly inserted in
the power socket.
There is no power at the socket.
The appliance
does not start:
The main fuse has blown.
The programme selector dial is not
correctly positioned and the button
4 has not been pressed.
The delay start has been selected.
2
5. place a bowl on the floor;
6. let the drain hose run along the floor,
place the external extremities of the
drain and inlet hoses in the bowl
placed on the floor and let water drain
out completely;
7. screw the water inlet hose back on and
reposition the drain hose again;
When you intend to start the appliance up
again, make sure that the room tempera-
ture is above 0°C.
Before contacting your local Service Centre,
please carry out the checks listed below.
Solution
Close the door firmly.
Insert the plug into the power
socket.
Please check your domestic electri-
cal installation.
Replace the fuse.
Please turn the selector dial and
press the button 4 again.
If the laundry are to be washed
immediately, cancel the delay
start.
22