IKEA FWM6 Handbuch Seite 23

ENGLISH
Problem Possible cause
The water tap is closed The red in-
dicator light of button 4 blinks).
The inlet hose is squashed or
kinked (The red indicator light of
button 4 blinks).
The appliance
The filter in the inlet hose or the in-
does not fill:
let valve filter are blocked (The red
indicator light of button 4 blinks).
The door is not properly closed
(The red indicator light of button 4
blinks).
The drain hose is squashed or
kinked (The red indicator light of
button 4 blinks).
The appliance The drain filter is clogged (The red
does not emp- indicator light of button 4 blinks).
ty:
An option or a programme that
ends with the water still in the tub
or a that eliminates all the spinning
phases has been selected.
The appliance The mains supply has been cut off.
switches off
during the
washing phase:
The electronic unbalance detection
device has cut in because the laun-
dry is not evenly distributed in the
drum. The laundry is redistributed
The appliance
by reverse rotation of the drum.
spinning phase
This may happen several times be-
starts late or
fore the unbalance disappears
does not start:
and normal spinning can resume.
If, after 10 minutes, the laundry is
still not evenly distributed in the
drum, the appliance will not spin.
Too much detergent or unsuitable
There is water
detergent (creates too much foam)
on the floor:
has been used.
Solution
Open the water tap.
Check the inlet hose connection.
Clean the water inlet filters. (See
"Cleaning the water inlet filters"
for more details).
Close the door firmly.
Check the drain hose connection.
Clean the drain filter.
Select the draining or spinning
programme.
Wait for the electricity restore.
The appliance will start again from
the same interrupted washing
phase.
Redistribute the load manually or
load more laundry and select the
spin programme.
Reduce the detergent quantity or
use another one.
23