Safety Regulations; Layout And Items Supplied - EINHELL GE-LM 36/4in1 Li Originalbetriebsanleitung

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols (Fig. 49):
1. Warning!
2. Wear protective headgear, goggles and ear-
muff s!
3. Protect the tool from rain and damp!
4. Maximum cutting length
5. Electric shock can cause fatal injury. Keep a
distance of at least 10 m from power cables!
6. Read the directions for use before using the
tool for the fi rst time!
7. Wear sturdy, non-slip footwear!
8. Watch out for falling and catapulting parts!
9. Keep your distance.
10. Direction of chain movement and teeth
11. Wear protective gloves
12. Bystanders must keep a distance of at least
15 m from the tool.
13. The tool continues to run!
14. Beware of recoil!
15. Do not use any saw blades.
The latest operating instructions can also be
downloaded as a PDF fi le from our website at
www.Einhell-Service.com.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Warning!
Read all the safety information, instructions,
illustrations and technical data provided on
or with this power tool. Failure to adhere to the
following instructions may result in electric shock,
fi re and/or serious injury.
Keep all the safety information and instruc-
tions in a safe place for future use.
Anl_GE_LM_36_4in1_Li_SPK9.indb 34
GB

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. Battery mount
2. On/Off switch
3. Switch lock
4. Handle
5. Harness holder
5a. Wing nut
6. Steady grip holder
7. Union nut
8. Connecting tube
9. Lock release
10. Oil tank cap
11. Motor unit (unit with tube)
12. Extension tube
13. Trimmer/scythe module (unit with connecting
tube)
14. Pole-mounted pruner module
15. Hedge trimmer module
16. Complete steady grip
16a. Handle screw
16b. Side steady grip
17. Harness with safety release
18. Saw chain
19. Cutter rail
20. Cutter rail guard
21. Guard for hedge trimmer blade
22. Multifunction tool (size 13/4mm) for pole-
mounted pruner
23. Guard hood
23a. Cutting line blade guard hood
24. Multifunction tool (size 19/cross-head) for
trimmer/scythe
25. Cutting blade
26. Hex key (5mm)
27. Pressure plate
28. Pressure plate cover
29. Hex nut (M10 self-locking, left-hand thread)
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
- 34 -
20.11.2020 08:35:34