Herunterladen Inhalt Inhalt Diese Seite drucken

Mounting The Forcer; Primäreinheit Montieren - Ametek dunkermotoren Servo Tube SA 38 Serie Installation

Linearmotoren
Inhaltsverzeichnis

Werbung

6.3.1

Mounting the forcer

A
B
C
In the entire circumference of the housing there are T-slots,
which are used for mounting the forcer. For the grooves,
DIN508 T-slot nuts in stainless steel must be used. The pre-
ferred mounting surface of the forcer is on the opposite side
of the connector plug.
The number of slot nuts results from the overall length of
the motor:
SC3806: 6 pieces
»
SC3810: 8 pieces
»
SC3814: 10 pieces.
»
The preferred mounting surface of the forcer
opposite side of the connector plugc
Can be mounted in any orientation.
Ensure a free movement between forcer
X
D
rod
.
For the installation of the thrust rod
X
perly aligned and positioned prior to mounting.
E
Mount the forcer
using slot nuts
X
Use suitable screws for mounting.
X
Consider a sufficient tightening torque of the screws.
X
The recommended tightening torques are: T-nuts with
M5 thread: 6 Nm (dry running i.e. without thread lock).
Version 02-02-2021
6.3.1
Im gesamten Umfang des Gehäuses befinden sich T-Nu-
ten, welche zur Montage der Primäreinheit dienen. Für die
Nuten sind Nutensteine DIN 508 in Edelstahl zu verwen-
den.
Die Anzahl der Nutensteine ergibt sich aus der Baulänge
des Motors:
»
»
»
E
is on the
Auf der Gegenseite
B
.
vorzugte Montagefläche der Primäreinheit
Sie dürfen den Antrieb in jeder Ausrichtung montieren.
E
and thrust
X
D
, it must be pro-
X
C
X
X
X
Servo Tube SA/ SC 38
Primäreinheit montieren
SC3806: 6 Stück
SC3810: 8 Stück
SC3814: 10 Stück.
B
der Anschlussstecker ist die be-
Stellen Sie sicher, dass eine freie Bewegung zwischen
E
Primäreinheit
und Magnetstange
Richten Sie zur Montage der Magnetstange
her ordnungsgemäß aus und positionieren Sie die Mag-
D
netstange
.
Befestigen Sie die Primäreinheit
B
.
Verwenden Sie für das Befestigen geeignete Schrauben.
Achten Sie auf ein ausreichendes Anzugsmoment der
Schrauben. Die empfohlenen Anzugsmomente sind:
T-Nutensteine mit M5 Gewinde: 6 Nm (trockenlaufend i.e.
ohne Gewindesicherung).
E
D
E
.
D
möglich ist.
D
diese vor-
E
mittels Nutensteinen
Page/Seite 39 / 61

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis