After Finishing Work; Transporting - Stihl RM 4.0 RT Gebrauchsanleitung

12 After Finishing Work

► Pull control bar for self-propulsion (1) fully in
the direction of the handlebar and hold so the
thumb encloses the handlebar.
The lawn mower starts moving.
11.3.2 Disengaging Self-propulsion
► Release the control bar for self-propulsion.
► Wait until the lawn mower comes to a stand‐
still.
11.4 Mulching
During mulching, the cut grass is chopped up
several times through a special air flow guidance
system in the mower blade area and then blown
back into the turf. The clippings remain on the
lawn surface where they partially decompose
and serve as a natural fertiliser. To ensure a per‐
fect, thick lawn, mulch regularly, removing one
third of the grass height.
Requirements for good mulching results:
– Frequency: at least twice a week in the spring
(main period of growth) and once a week in
the summer and autumn.
– Mow the lawn when dry if possible.
– Use well-sharpened cutting blades.
– Select a low rate of feed.
– Vary the mowing direction and ensure that the
mowing strips overlap.
– Always mow very tall grass in stages.
0478-111-9655-A
► If working with self-propulsion engaged: drive
the lawn mower forwards in a controlled man‐
ner.
► If working with self-propulsion disengaged:
push the lawn mower forwards slowly and in a
controlled manner.
12 After Finishing Work
12.1 After Finishing Work
► Stop the engine.
► If the lawn mower is wet: allow the lawn
mower to dry.
► Clean the lawn mower.

13 Transporting

13.1 Transporting the Lawn Mower
► Stop the engine.
The blade must not be turning.
► Detach the spark plug socket.
Pushing the lawn mower
► Push the lawn mower forwards slowly and in a
controlled manner.
Carrying the lawn mower
► Wear work gloves made from resistant mate‐
rial.
English
29