Disposal And Recycling; Troubleshooting - Scheppach 5907803901 Original Bedienungsanleitung

• Protect the stored machine from direct sunlight;
put it in a darkened area, if feasible.
• Do not wrap the machine into bags or covers made
of nylon or plastic, as dampness may develop.

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE).

13. Troubleshooting

Problem
Motor does not start.
Unusual vibrations
Device starts but blocks under
slight load and cuts off auto-
matically.
22 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
No power supply (power failure)
Mains cable defective.
Motor or switch defect
Beater defective.
Chuck defective.
Non-intended material to be mixed.
Extension cable too long, or crosssec-
tion too small.
Socket too far away from main connec-
tion, and cross-section of connection
lead too small.
This product must be disposed of at a designated
collection point. This can occur, for example, by
handing it in at an authorised collecting point for the
recycling of waste electrical and electronic equip-
ment. Improper handling of waste equipment may
have negative consequences for the environment
and human health due to potentially hazardous sub-
stances that are often contained in electrical and
electronic equipment. By properly disposing of this
product, you are also contributing to the effective
use of natural resources. You can obtain information
on collection points for waste equipment from your
municipal administration, public waste disposal au-
thority, an authorised body for the disposal of waste
electrical and electronic equipment or your waste
disposal company.
Remedy
Check fuses
Exchange defect cable, respectively check
extension cable, (by electrician)
Never use defect lead
To correct the problem, refer to the manu-
facturer or other approved service centre.
Replace the beater.
To correct the problem, refer to the manu-
facturer or other approved service centre.
Incorrect processing. Follow the processing
instructions from the supplier.
Extension cable at least 1,5 mm
mum 25 m long.
Cross- section of at least 2,5 mm
cables.
, maxi-
2
in longer
2