ULTIMATE SPEED UPK 10 C1 Originalbetriebsanleitung Seite 39

Using the device
Switch on the integrated com-
„ „
pressor by switching the On/Off
switch for the compressor
"On" (position I).
The compressor will start and
„ „
pump up the inflatable item.
You can switch off the compressor
„ „
at any time by switching the On/
Off switch for the compressor
to "Off" (position 0).
Otherwise, the compressor will
„ „
switch off automatically once the
inflatable item has reached the
preset pressure.
In this case, once the preset
„ „
pressure has been reached and
the compressor automatically
switches off, switch the On/Off
switch for the compressor
(position 0).
Disconnect the inflatable item
„ „
from the compressed air hose
as described in the previous
17
section.
At the end of work, screw the
„ „
compressed air hose
the hose connection
powerbank with compressor
Subsequently, plug the cover cap
for hose connection
the hose connection
Attention: The hose connection
of the powerbank with compressor
heats up during operation. Make
1
sure that you do not come into
contact with the hose connection
during operation to avoid suffering
38 GB/IE
burns. At the end of work, wait
for at least 10 minutes before you
to unscrew the compressed air hose
2
back off the hose connection
the powerbank with compressor
Note: After switching on the
powerbank with compressor
with the powerbank switch
2
device switches off automatically
after approximately 20 seconds if
the compressor is not started or if no
consumables are connected.
Note: The digital pressure gauge
with pressure display
powerbank with compressor
not trade-approved. Therefore, if
off
inflatable items have been pumped,
2
in which incorrect pressure can
be dangerous (e.g. tyres), find a
specialist unit with a trade-approved
device and check the pressure of the
inflatable item.
back off
Tips for use
17
of the The device is not intended for con-
15
. tinuous operation. The device was
1
designed to create air pressure – not
back on to an air flow. Please do not use the
16
. device for more than 7 minutes at a
15
time on items with a large volume,
to avoid overheating and damage
15
to the device. Then let the device
cool down for at least 15 minutes.
We recommend first filling a large-
volume item with air, in order to then
15
generate the required pressure with
17
of
15
.
1
1
, the
9
of the
6
is
1