Faq - ULTIMATE SPEED UPK 10 C1 Originalbetriebsanleitung

Step
2. First connect
the red clamp
(A) to the
positive pole
of the vehicle
battery and
then connect
the black bat-
tery clamp (B)
to the negative
pole
(see Fig. 1).
3. Starting up the
vehicle.
Attention: As soon as the
„ „
vehicle starts, remove the jump
lead from the powerbank with
18
compressor
1
and firstly disconnect the black
battery clamp (B) and then the
red clamp (A) from the battery
poles. Otherwise, it could result
in dangerous situations!
Leave the vehicle engine running.
„ „
LEDs
The red Error
LED
flashes, a
20
short alarm signal
sounds.
The red Error
LED
flashes, a
20
continuous alarm
signal sounds.
The red Error LED
flashes once, a
20
continuous alarm
is sounded and
then followed by
two short alarm
sounds.
Green Start LED
and the red
19
Error LED
flash
20
alternately. After
1–2 seconds only
the green LED
glows.
within 30 seconds
Using the device / FAQ
Meaning /
Error
The tempera-
ture is too high,
possibly due to
several jump
start attempts.
Battery clamps
(A) and (B) are
the wrong way
round.
It is caused by
a short circuit
or the battery is
leaking.
The connection
is correct
19
z FAQ
Q: Question
A: Answer
Q: How long does it take to
fully charge a mobile phone
with the device?
A: With a battery capacity of
3500 mAh: Approx. 3–4 hours if
connected to the USB output
Solution
Disconnect
the black (B)
battery clamp
first and then
the red clamp
(A) from the
battery poles.
Start again
from step 1.
Carry on with
step 3.
GB/IE 41