Switch On Lighting; Using The Jumpstart Feature - ULTIMATE SPEED UPK 10 C1 Originalbetriebsanleitung

Using the device
z Switch on lighting
Light mode
To switch on the LED light
„ „
press the powerbank switch
for 3 seconds.
Press the powerbank switch
„ „
for another 3 seconds in order to
switch the LED light
Flash mode
To switch on the LED light
„ „
the flash or SOS mode, first press
the powerbank switch
3 seconds. Then the LED light
will be permanently lit.
Briefly press the powerbank
„ „
switch once again and the LED
9
light will switch to flash mode.
7
Briefly press the powerbank
„ „
switch once again and the LED
9
light will switch to SOS mode.
7
There will be 3 short flashes,
3 long flashes and another
3 short flashes.
Step
1. Connect the
jump lead
18
of the power-
bank with com-
pressor to
1
the car-jump-
start-outlet
8
of the power-
bank with
compressor
1
40 GB/IE
,
7
9
9
back off.
7
in
7
for
9
7
LEDs
Red Error LED
continuously lit on
the jump lead
Green Start LED
and the red
19
flash
Error LED
20
.
alternately.
Briefly press the powerbank
„ „
switch
9
off the LED light
Caution! Do not look
directly at the LED lights
this can damage your eyes.
Note: It is not possible to turn on
the light while the powerbank with
compressor
z Using the jumpstart
feature
When using the jumpstart, make
„ „
sure that at least 3 indicator
lights are permanently illumi-
13
nated.
1
Meaning /
Error
The voltage
is
20
determined in
the powerbank
.
18
with compressor
is not enough
1
to start the car.
Powerbank with
compressor
ready.
once again to switch
.
7
is charging.
1
B A
2. 1.
Solution
Charge the
powerbank
with compres-
sor
.
1
Carry on with
step 2.
1
as
7