Layout - Parkside PET 32 Bedienungs- Und Sicherheitshinweise

Anleitung_PET_32_4257874:_
Additional Safety rules
Always pull the power plug whenever the
tool is not being used, before carrying out
any maintenance work or changing the
staples or nails.
Wear the necessary protective clothing, in
particular safety goggles, when working with
the electric stapler.
Always keep the magazine and all guides
free of foreign bodies. Before using the tool
always make sure that there are no foreign
bodies in the magazine or guides.
Make sure that the tool is kept clean and
also that the air vents are free and clean.
Never use the tool with staples or nails
which are not suitable for it. The use of other
staples and nails may cause injury or
damage the tool. Read the operating
instructions for notes on which staples and
nails are suitable.
If the electric stapler is in use over a long
period, the tool may heat up as it is
designed for temporary operation. After
using the tool for a long period, pull the
power plug and allow the tool to cool.
When working with the electric stapler, keep
your fingers and other body parts away from
the stapler head.
Never use the stapler to fasten electric
cables.
Never allow children to use the electric
stapler.
Do not use the tool when other persons or
animals are in the near vicinity unless they
are wearing appropriate protective clothing.
Never shoot staples or nails into the air.
Staples and nails shot at short distance can
lead to serious injuries.
Make sure that there are no other persons
in the direct vicinity when working with the
electric stapler.
Use the electric stapler only for joining soft
materials such as wood or fabrics.
Take special care when working with thin
materials. Make sure that the staples or
nails are not too long or they may stick out
of the workpiece or may even pass all the
way through. Make sure that no part of your
body is on the other side of the workpiece.
Make sure that the workpiece is held
28.01.2009 15:03 Uhr Seite 31
securely by a clamping device or a vise.
Never hold the workpiece you wish to staple
simply in your hands.
Always guide the power cable away from
the back of the tool. Make sure not to staple
the power cable of the electric stapler by
accident.
Never leave the loaded tool unsupervised.
Never operate the electric stapler without
staples or nails.
If a staple or nail becomes jammed in the
feed shaft, pull out the power plug and
remove the jammed staple or nail as
described in the operating instructions.
Save this instructions.
CAUTION!
For your own safety, use only staples
and nails listed in the directions for use.
The use of staples and nails other than
those listed in the directions for use
may result in risk of injury.
Be sure to pull out the power plug
whenever the tool is not being used,
each time before carrying out any
maintenance, and whenever you want to
change the staples or nails!
It is important to wear suitable
protective clothing, and particularly
safety goggles, when working with the
electric stapler/nailer.
Please follow the safety instructions.
3. Layout (Fig. 1)
1 Trigger
2 On/Off switch
3 Stapling controller
4 Magazine slide
5 Magazine
6 Filling level indicator
7 Stapler head
GB/
MT
31