SCOPREGA TURBO MAX 12 V Bedienungsanleitung Seite 11

TROUBLESHOOTING
P R O B E L M
Wrong connection of the power cord to
the battery.
Low battery voltage.
Inflator will not start
ON push button not ON.
The safety fuse is blown.
n I a l f o t s i r
Wrong port connected.
Inflator will not
Wrong pressure setting.
inflate/deflate
START button not on.
ACCESSORIES
Recommended accessories for use with your inflator are available from your local dealer or authorized
service center.
WARNING
ATTENZIONE
The use of any accessories not recommended for use this inflator could be hazardous.
* ONLY FOR TURBO MAX KIT 12V and TURBO MAX KIT 24V-EV
1 1 . . C C O O N N N N E E C C T T O O R R A A S S S S E E M M B B L L Y Y
·
Put the lids and the small red plugs onto the cable ends (pic. 1).
After crimping the faston, it is recommended to solder the connector-to-cable terminal to ensure
current flow (pic. 1 – arrow).
·
Insert the fastons into their seats, checking clip direction (pic. 2) and polarity (pic. 4).
·
Adjust the lids and the red plugs onto the connector (fig. 3).
1
P O S S B I E L C A U E S
.
a d a m e g . d
2
P O S S B I E L S L O
Make sure polarity is correct (red is positive).
Recharge the battery.
Push ON push button.
Replace the fuse with one of the same size (40 A or 70 A).
C n o c a t a t C S O P E R G A e s v r e c i e c t n
Connect the inflation hose to the proper port.
Adjust setting on the pressure knob.
Push START button after pushing ON push button.
3
Instructions manual
T U O I N
. r e
4
Rev. 01-2020