Operation; Transportation And Storage; Maintenance - Ryobi RCS1935 Bedienungsanleitung

chain tension again, do not tension the chain too tight.
again.
ADJUSTING THE CHAIN TENSION
See page 235. See page 246.
1.
To increase the chain tension, turn the chain tensioner
The chain tension is correct when the gap between the
distance between the bar and the chain cutters.

OPERATION

ADDING CHAIN LUBRICATING OIL
See page 234.
WARNING
running without lubricant, guide bar and saw chain can
before starting to use the chain saw.
1. Clear surface around the oil cap to prevent
contamination.
filling.
any spillage.
5.
Recommended chain lubricating oil
The manufacturer recommends you use only Ryobi
HOLDING THE CHAIN SAW
See page 235.
Always hold the chain saw with your right hand at the rear
handle and your left hand at the front handle. Grip both
Ensure that your left hand is holding the front handle so
that your thumb is underneath.
WARNING
area of cutting. Apart from the danger of electrocution,
untidy cables cause falls and trips.
STARTING THE CHAIN SAW
See page 235.
1.
guard.
CHECKING AND OPERATING CHAIN BRAKE
1.
while the chain is rotating rapidly. Be sure to maintain
both hands on the saw handles at all times.
and pulling toward the front handle until you hear a
WARNING
for repair prior to use.

TRANSPORTATION AND STORAGE

See page 248, 249.
Stop the product, disconnect from its power supply and
allow it to cool before storing or transporting.
Clean all foreign material from the product. Store it in
to children. Keep away from corrosive agents such
outdoors.
Fit guide bar cover before storing the unit, or during
transportation.
For transportation, secure the machine against
movement or falling to prevent injury to persons or
damage to the machine.

MAINTENANCE

WARNING
Use only original manufacturer's replacement parts,
accessories and attachments. Failure to do so can
cause possible injury, poor performance and may void
your warranty.
EN
English | 7