Operation; Transportation And Storage; Maintenance - Ryobi RCS2340 Originalanleitung

it in place.
7. Replace the sprocket cover and turn the guide bar
locking knob until nearly tight, turn the chain tension
adjustment ring until the saw chain is properly
tensioned. The guide bar must then be pushed
upwards, check chain tension again, do not tension the
chain too tight.
8.
again.
ADJUSTING THE CHAIN TENSION
See page 235. See page 246.
1. Loosen the guide bar locking knob slightly by turning it
counterclockwise.
2. To increase the chain tension, turn the chain tensioner
adjustment ring clockwise and check the chain tension
frequently. To reduce the chain tension, turn the chain
tensioner adjustment ring counterclockwise and check
the chain tension frequently.
3. The chain tension is correct when the gap between the
distance between the bar and the chain cutters.
Tighten the guide bar locking knob by turning it
clockwise.

OPERATION

ADDING CHAIN LUBRICATING OIL
See page 234.
WARNING
Never work without chain lubricant. If the saw chain is
running without lubricant, guide bar and saw chain can
be damaged. It is therefore essential to check the oil
level in the oil level gauge frequently and every time
before starting to use the chain saw.
1. Clear surface around the oil cap to prevent
contamination.
2. Unscrew and remove the cap from the oil tank.
3.
gauge. Ensure that no dirt enters the oil tank while
filling.
any spillage.
5.
Recommended chain lubricating oil
The manufacturer recommends you use only Ryobi
HOLDING THE CHAIN SAW
See page 235.
Always hold the chain saw with your right hand at the rear
handle and your left hand at the front handle. Grip both
Ensure that your left hand is holding the front handle so
that your thumb is underneath.
WARNING
Always keep the power cable tidy and away from the
area of cutting. Apart from the danger of electrocution,
untidy cables cause falls and trips.
STARTING THE CHAIN SAW
See page 235.
1. Connect to power outlet. Make sure the chain brake
is in the run position by pulling back on the lever/hand
guard.
2.
then press the on/off trigger.
CHECKING AND OPERATING CHAIN BRAKE
1. Engage the chain brake by rotating your left hand
around the front handle. Allow the back of your hand to
push the chain brake lever/hand guard toward the bar
while the chain is rotating rapidly. Be sure to maintain
both hands on the saw handles at all times.
2. Reset the chain brake back into the Run position by
grasping the top of the chain brake lever/hand guard
and pulling toward the front handle until you hear a
click.
WARNING
If the chain brake does not stop the chain immediately, or
if the chain brake will not stay in the run position without
assistance, take the saw to an authorised service centre
for repair prior to use.

TRANSPORTATION AND STORAGE

See page 248, 249.
Stop the product, disconnect from its power supply and
allow it to cool before storing or transporting.
Clean all foreign material from the product. Store it in
to children. Keep away from corrosive agents such
outdoors.
Fit guide bar cover before storing the unit, or during
transportation.
For transportation, secure the machine against
movement or falling to prevent injury to persons or
damage to the machine.

MAINTENANCE

WARNING
Use only original manufacturer's replacement parts,
accessories and attachments. Failure to do so can
cause possible injury, poor performance and may void
your warranty.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
English | 7