Use As An Autonomous Cutting Saw (Fig. 1 - 8B); Maintenance - Storage - Assistance - Disposal - Femi 785XL Gebrauchs- Und Wartungsanleitung

4.2

USE AS AN AUTONOMOUS CUTTING SAW (Fig. 1 - 8B)

a) Secure the workpiece to be cut in the clamp using lever (12).
b) With your left hand lift the arm to its maximum height.
c) Lower the head until it is 5 mm from the workpiece.
d) With your right hand activate the button (28) to start the cutting process and the side locking
button (18).
DANGER - CAUTION
TO AVOID BREAKING THE BLADE, REDUCE PRESSURE AS SOON AS THE
BLADE COMES INTO CONTACT WITH THE WORKPIECE.
e) Let go of the head and wait for cutting to be completed up to the end of the stroke,
DANGER - CAUTION
• Never bring hands anywhere near the cutting zone until the head has returned
• Let the cut piece fall onto the base of the machine.
DANGER - WARNING
IN THE EVENT OF EXCESSIVE CUTTING PRESSURES, THE CURRENT LIMITER
WILL TRIP.
LESSEN THE CUTTING PRESSURE TO SAFEGUARD THE MACHINE.

5. MAINTENANCE - STORAGE - ASSISTANCE - DISPOSAL

NOTES
Routine maintenance operations which can be performed by the user are described
below.
Have the machine repaired by expert personnel only. This machine complies with all
the relevant safety prescriptions. Repairs to the machine must be carried out by skilled
personnel only using original spare parts. Failure to observe this recommendation could
jeopardize user safety.
DANGER - WARNING
• BEFORE PERFORMING ANY MAINTENANCE WORK, PLACE THE MACHINE
• PLACE THE POWER CABLE IN A COIL NEAR THE MACHINE.
Downloaded from www.Manualslib.com
to its full height and the blade has come to a complete standstill.
IN SAFETY CONDITIONS, SEE HEADING "GENERAL SAFETY RULES".
manuals search engine
EN
Art. ABS NG160
33