Electrical Connection; Adjustments - Femi 785XL Gebrauchs- Und Wartungsanleitung

2.8.

ELECTRICAL CONNECTION

Safety Standards for electrical connections
- Check that the electric supply system to which the machine is to be connected is earthed
in accordance with the relative safety regulations in force.
DANGER - WARNING
C H E C K T H AT T H E P O W E R S U P P LY S Y S T E M I S E Q U I P P E D W I T H A
THERMOMAGNETIC CIRCUIT BREAKER TO PROTECT ALL CONDUCTORS
FROM SHORT CIRCUIT AND OVERLOADS (SEE APPENDIX).
Preliminary tests and checks after connection
DANGER - WARNING
- BEFORE CONNECTING THE MACHINE TO THE ELECTRICAL SYSTEM, CHECK
- ONCE CONNECTED, TO AVOID ANY POSSIBLE RESIDUAL RISKS OF
Specific characteristics of the electrical system
DANGER - WARNING
THE SAW'S ELECTRICAL SYSTEM IS FITTED WITH A DEVICE WHICH
- SHOULD THE MACHINE SUDDENLY CUT OUT THERE IS NO CAUSE FOR

3. ADJUSTMENTS

DANGER - WARNING
- PUT THE MACHINE IN SAFETY CONDITIONS (SEE "GENERAL SAFETY
- WEAR PROTECTIVE GLOVES.
- ALL THE PROCEDURES FOR MACHINE ADJUSTMENTS AND USE DESCRIBED
DANGER - CAUTION
- AT THE END OF EVERY ADJUSTMENT OPERATION, CHECK THAT ALL
- AT THE END OF EVERY ADJUSTMENT OPERATION MAKE SURE NO TOOLS
Downloaded from www.Manualslib.com
THAT THE MAINS VOLTAGE MATCHES THE VOLTAGE INDICATED ON THE
MACHINE ITSELF.
TRIPPING AND FALLING, MAKE SURE THAT THE POWER SUPPLY CABLE
LIES COMPLETELY ON THE GROUND AND IS NOT AT ANY POINT RAISED
IN THE AIR.
AUTOMATICALLY OPENS THE CIRCUIT IF THE VOLTAGE DROPS BELOW
A MINIMUM SET LIMIT AND INHIBITS AUTOMATIC RESET OF OPERATING
CONDITIONS WHEN THE VOLTAGE RETURNS TO THE SET RATED
LEVELS.
ALARM. CHECK THAT THERE HAS NOT BEEN A VOLTAGE FAILURE IN THE
MAINS SUPPLY.
REGULATIONS")
IN THE FOLLOWING HEADINGS MUST BE PERFORMED ONLY AFTER THIS
INSTRUCTION, USE AND MAINTENANCE MANUAL HAS BEEN READ AND
UNDERSTOOD IN FULL.
FASTENERS ARE SECURELY TIGHTENED.
HAVE BEEN LEFT ON THE MACHINE.
manuals search engine
EN
29