ABL eMH3 Bedienungsanleitung/Sicherheitshinweise Seite 24

24
| Wallbox eMH3 – Charging procedure
NOTE
Authorisation via RFID
The RFID module is located in the upper part of the housing cover, which, depending on the model
variant and configuration of the Wallbox eMH3, is used for the authorisation of the charging procedure
by the user.
ƒ Master with or without Slave: To authorise charging procedures via RFID, the Wallbox eMH3
must be operated with a backend. This operating state is indicated by the flashing green LED of the
RFID module.
ƒ Slave without Master: If a Slave wallbox has been configured for operation without a Master, you
must authorise the charging procedure via RFID if the blue LED of the RFID module is flashing twice
per cycle.
If the blue LED is only flashing once per cycle, the RFID module is inactive and the charging proce-
dure will start automatically upon being requested by the vehicle: Steps 5 to 8 as described below
do not apply in this case.
5
Check the LED indicators of the RFID module
(illustration: 1 cycle).
y If RFID access control is active, the green
LED flashes once or the blue LED flashes
twice.
6
Check the LED indicators of the RFID module
(illustration: 1 cycle).
y If the charging procedure must be author-
ised via RFID card, the green LED flashes
once or the blue LED flashes twice.
7
Hold a valid RFID card in front of the RFID
module on the housing cover.
8
Check the LED indicators of the RFID module
(illustration: 1 cycle).
y While the RFID card is being checked, the
green LED flashes every two seconds.
y When authorisation has been given, the
green LED is ON for two seconds and then
turns OFF.
1 sec 1 sec 1 sec
1 sec 1 sec 1 sec
1 sec 1 sec 1 sec
1 sec 1 sec
or
1 sec 1 sec
or
1 sec 1 sec