Sony SJ700-015 Handbuch Seite 23

• If the gap between the B and C surfaces is set to
± ±
9 0.1 mm (0.354" 0.004").
Remove the two screws securing the scale and the slider
holder and move the slider by hand to align it with the
brackets. Secure the slider in place in the position where
the protruding portion (D) of the slider holder comes into
contact with the scale. Finally, remove the slider holder
from the slider.
Note
Attempting to move the bracket side when the slider
holder is secured could cause the brackets to strike the
slider. Therefore, always move only the slider side.
Protruding
portion (D)
Slider holder
C
Clearance between
B and C surface
Fig. 3-9
B
Unit: mm (inch)
(2) When the slider mounting surface has yet to meet
the specifications
When the mounting surface of the machine is a casting
surface, use a bracket. Place the bracket on the
underside of the slider without loosening the screws
that hold the slider holder. Adjust the position of the
bracket and mount it with the supplied M4×14 bolts.
Slider holder
Scale
Slider
Mounting bracket
Fig. 3-10
2 Plain washers
(S) (accessory)
2-M4×14
(accessory)
4 (0.16") to 6 (0.24")
Unit: mm (inch)
13