Setting Down, Transportation And Storage - Miele Blizzard CX1 Gebrauchsanweisung

en
During vacuuming
 When vacuuming, pull the cleaner be-
hind you on its wheels. You can stand
it upright for vacuuming stairs and
curtains etc.

When vacuuming especially fine
dust, e.g. sawdust, sand, flour,
talcum powder etc., electrostatic
charges build up naturally. Under
certain conditions electrostatic
charges will be released. To avoid
the unpleasant effects of these elec-
trostatic discharges, a metal inlay
has been incorporated into the un-
derside of the handle. Please make
sure that you keep your hand in con-
stant contact with this metal strip
during vacuuming.
If your vacuum cleaner is fitted with
an Eco Comfort handle, make sure
that your hand is in contact with the
top, arched part of the handle at all
times. The metal inlay is fitted in the
top of this arched component (dia.
20, 21 + 22).
If a large amount of dust has been va-
cuumed at once, the ComfortClean
self-cleaning function should be started
manually either during a vacuuming
pause or straight away. This enables
the vacuum cleaner to achieve the very
best cleaning performance again
straight away (see "Maintenance -
Starting the ComfortClean self-cleaning
function manually").
Interrupting operation (dia. 17)
(for models with radio controls on the
handle)
44
The vacuum cleaner can be paused for
short breaks whilst vacuuming.
 Press the Standby button  on the
handle.

The Standby button is designed
to pause the vacuum cleaner for
short periods of time whilst vacuum-
ing. Do not leave the vacuum cleaner
in Standby mode for long periods.
This can cause overheating and
damage.
An LED will indicate each time a button
is pressed on the handle.
At the end of the pause you can do one
of the following:
 Press the Standby button  again to
switch the vacuum cleaner back on at
the setting you were using before
pausing it.
 Press the + button to switch the va-
cuum cleaner back on using the
highest power setting.
 Press the - button to switch the va-
cuum cleaner back on using the low-
est power setting.
Setting down, transportation
and storage
Park System for pauses during
vacuuming (dia. 23)
The Park System allows you to conveni-
ently park the suction tube and floor-
head during pauses.
 Slot the floorhead or floorbrush into
the parking attachment on the va-
cuum cleaner.