Splashguard - Kenwood KVC51 Bedienungsanleitungen

To fit and use your

Splashguard

1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the underside
of the mixer head
The hinged section should be positioned as
shown.
4 Insert required tool.
5 Lower the mixer head.
• During mixing, ingredients can be added
directly to the bowl via the hinged
section of the splashguard
• You do not need to remove the
splashguard to change tools.
6 Remove the splashguard by raising the
mixer head and pushing it down.
until fully located.
8
.
9
K-beater & Whisk
whisk and K-beater should be almost
Dough Hook
Tool Adjustment
The tools are set to the correct height for
the bowl supplied in the factory and should
not require adjustment.
However, if you wish to adjust the tool use
a suitable sized spanner:
TYPE KVC51 = 15mm
TYPE KVL61 = 19mm
Then follow the instructions below:
1 Unplug the appliance.
2 Raise the mixer head and insert the
whisk or beater.
3 Lower the mixer head. If the clearance
needs to be adjusted, raise the mixer
head and remove the tool. Ideally the
touching the bottom of the bowl
4 Using a suitable spanner loosen the nut
sufficiently to allow adjustment of the
shaft . To lower the tool closer to the
bl
bottom of the bowl, turn the shaft anti-
clockwise. To raise the tool away from
the bottom of the bowl turn the shaft
clockwise.
5 Re-tighten the nut.
6 Fit the tool to the mixer and lower the
mixer head. (Check its position see
points above).
7 Repeat the above steps as necessary
until the tool is set correctly. Once this is
achieved tighten the nut securely.
• Note: Spanner
illustration purpose only.
This tool is set at the factory and should
require no adjustment.
7
bk
shown is for
bl
.