Maintenance; Troubleshooting - Makita UR100D Betriebsanleitung

MAINTENANCE

Detaching the shoulder harness
WARNING:
Always be sure that the tool is
switched off and battery cartridge is removed
before attempting to perform inspection or
maintenance on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any
or adjustment should
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
Use nylon cord with diameter specified in "SPECIFICATIONS" only. Never use heavier line,
WARNING:
metal wire, rope or the like. Use recommended nylon cord only, otherwise it may cause damage to the tool and
result in
WARNING:
Make sure that the cover of the nylon cutting head is secured to the housing properly as
described below.
the
serious
Replace the nylon cord if the cord is not feeding any more.
►
Fig.32: (1) Up to 8 m (2) 70 - 80 mm

TROUBLESHOOTING

Before asking
you find
manual, do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using
Makita replacement parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
It does not reach maximum RPM.
from accidental start-up.
other maintenance
be performed by
serious personal
Failure to
nylon cutting
personal injury.
for repairs,
a problem
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
Replacing the nylon cord
Cleaning the tool
Clean the tool by wiping off dust, dirt, or cut off grass
with a dry cloth or one dipped in soapy water and wrung
out. If the cut off grass is adhered to the motor housing,
be sure to remove it.
►
Storage
The hole in the handle is convenient for hanging the tool
from a nail or screw on the wall. Before storing the tool,
raise the wire guard, shorten the shaft, and then fold the
front grip. ►
►
►
injury.
properly secure
head to
conduct your
that is
24 ENGLISH
Fig.28: 1. Motor housing
Fig.29:
Fig.30: 1. Front grip 2. Shaft
Fig.31: 1. Hole
the cover
fly apart
own inspection first.
not explained in
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using of tool to allow it to cool down.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
1. Wire guard
may cause
resulting in
If
the