Parts Description; Functional Description - Makita UR100D Betriebsanleitung

a hot battery cartridge cool down before
charging it.

PARTS DESCRIPTION

Parts description (with nylon
cutting head)
►
Fig.4
1 Switch trigger
3 Lock lever
5 Nylon cutting head
7 Wire guard
9 Front grip
11 Indication lamp
FUNCTIONAL
DESCRIPTION
WARNING:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Failure to switch off and remove the battery cartridge
may result
personal
accidental start-up.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge. Failure to hold the tool and the
battery cartridge
them
your
damage to the tool and battery cartridge and a
personal
►
Fig.5: 1. Red indicator 2. Button 3. Battery
cartridge
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
2 Battery cartridge
4 Protector
6 Nylon cord
8 Thumb nut
10 Hanger for shoulder
harness
12 Lock-off button
in serious
injury from
firmly may
to slip
hands and result in
injury.
CAUTION:
fully until the red indicator cannot be seen. If not, it
someone around you.
CAUTION:
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Battery protection system
The tool is equipped with a battery protection system.
This system automatically cuts off power to the motor to
extend battery life.
The tool will automatically stop during operation if the
tool and/or battery are placed under one of the following
conditions:
Overloaded:
The tool is operated in a manner that causes it to draw
an abnormally high current.
In this situation, turn the tool off and stop the application
that caused the tool to become overloaded. Then turn
the tool on to restart.
If the tool does not start, the battery is overheated. In
this situation, let the battery cool before turning the tool
on again.
Low battery voltage:
The remaining battery capacity is too low and the tool
will not operate. If you turn the tool on, the motor runs
again but stops soon. In this situation, remove and
recharge the battery.
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator ►
Fig.6: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for a few seconds.
cause
off
Lighted
20 ENGLISH
Always install the battery cartridge
may accidentally
out of
causing injury
Do not install the battery cartridge
Indicator lamps
Of
f
fall
the tool,
to you or
Remaining
capacity
75% to 100%