Makita UR100D Betriebsanleitung Seite 21

NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Switch action
WARNING:
Before installing the battery
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns to
the "OFF" position when released.
WARNING:
For your safety, this tool is
equipped with the lock-off button which prevents
the tool from unintended starting. Never use the
tool if it starts when you pull the switch trigger
without pressing the lock-off button. Ask your local
Makita Service Center for repairs.
WARNING:
Never disable the lock function or
tape down the lock-off button.
NOTICE:
Do not pull the switch trigger forcibly
without pressing the lock-off button. The switch
may break.
►
Fig.7: 1. Switch trigger 2. Lock-off button
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, press the lock-off button and pull the
switch trigger. Release the switch trigger to stop. The
lock-off button can be pressed from either the right or
left side.
Indication lamp
Running the tool allows the indication lamp to show the
battery cartridge capacity status. ►
50% to 75%
Lamp
When the tool is also overloaded and has stopped
during operation, the lamp lights up in red. Refer to the
following table for the status and action to be taken for
the indication lamp.
25% to 50%
Indication lamp
The lamp blinks in
red.
0% to 25%
The lamp lights up
in red. (Note 1)
The lamp lights up
in red. (Note 1)
Note 1: The time at which the indication lamp lights up varies by
the temperature around the work area and the battery cartridge
conditions.
Nylon cutting head
NOTICE:
asphalt surface. Bumping to this kind of objects
may cause the tool damage.
NOTE: If the nylon cord does not feed out while
bumping the head, rewind or replace the nylon cord by
following the procedures in this manual.
NOTE: The bump and feed mechanism will not work
properly if the nylon cutting head is not rotating.
►
The nylon cutting head has a bump and feed
mechanism. To feed the nylon cord, bump the cutting
head against the ground while the tool is running. As the
nylon cord is feeding out, it will automatically be cut to
the proper length by the cutter.
Adjusting the position of the handle
and front grip
be sure to switch off the tool and remove the
battery cartridge from the tool. Failure to do so may
cause
Adjust
shaft
21 ENGLISH
Status
This indicates the
appropriate time to
replace the battery
cartridge when the
battery power
becomes low.
This function works
when the battery
power is almost
used up. At this
time, tool stops
immediately.
Autostop due to
overload.
Do not bump the tool to the concrete or
Fig.9: 1. Nylon cutting head 2. Cutter
CAUTION:
Before adjusting the shaft length,
a personal
the length
so that
Fig.8: 1.
Action to be taken
Recharge the
battery cartridge.
Recharge the
battery cartridge.
Turn off the tool.
injury.
of the
you can