Replacing The Lamp; Troubleshooting; Service Data - Leonard LBN1313X Benutzerinformation

Replacing the lamp

WARNING! Risk of electric
shock.
The lamp can be hot.

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.

Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
1. Turn off the oven.
A
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is deactivated.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
on the front frame of the oven cavity. Do
not remove the rating plate from the oven
cavity.
.........................................
.........................................
.........................................
Leonard 19
Remedy
Activate the oven.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.